rearsprocket.jpg
rearsprocket.jpg

  V-Mar sprockets

 Built in the USA!

100% Precision CNC machined from 7075 aircraft grade aluminum alloy, you cannot buy a better sprocket. We removed every little bit of material we could to make these sprockets as light as possible, using a unique design to maximize the strength while giving them a very distinctive look.

The key to a long lasting sprocket is the fit where each of the chain rollers fit into the teeth of the sprocket. Unlike stamped or cut sprockets, our fully CNC machined design insures a perfect fit between the chain and the sprocket, as well as the highest quality finish.

Bolt patterns avail include the 6-bolt Montesa pattern, 1997-2004 and the more common 4-bolt pattern used on the Gas Gas, Beta, Scorpa, Sherco and 2005-09 Montesa.

Sizes available in the 4 bolt pattern: 38 40 41 42 43 44 46 48 52

$69.95

-------------------------------------------------------------------------------------------------------------------------------------

bluespocket.jpg
bluespocket.jpg
bluespocket.jpg

Quality aluminum trials sprockets. Fits all modern trials bikes.

available in 41-42-43 & 44 tooth

Blue/red/Silver

$69.95

----------------------------------------------------------------------------------------------------------------------------

countershaft.jpg

Counter shaft sprockets

Sherco 9 or 10 tooth

Beta 9-10-11-12-13 tooth

$29.95

---------------------------------------------------------------------------------------------------------------------

chainblue.jpg
chainblue.jpg
chainblue.jpg
chainblue.jpg

520 chains

standard $44.99

gold $77.99

red or blue $108.99

-----------------------------------------------------------------------------------------------------

vmarchainguide.jpg

 V-Mar rubbing block
Replace your stock rubber chain guide with our super tough UHMW plastic guide. UHMW is an extremely tough industrial plastic that 'lubes like oil and wears like iron.' It is very slick and very tough at the same time. We have two sizes available, the standard width to replace the stock rubber guide using the standard chain, and a wider version designed for use with an o-ring chain. As with all V-Mar products, the chain guides come complete with all new mouting hardware. $20
---------------------------------------------------------------------------------------------------------------------

vmarsnailcam.jpg
vmarsnailcam.jpg
vmarsnailcam.jpg

 V-Mar cam snail adjusters

Our newest Snail cam is desigend specifically for the Montesa. We cut in a recess to lock in the axle, and counterbore the other snail so the axle nut will fully thread onto the axle.
Starting in '07 the GasGas uses a newly designed axle that presses onto one snail and uses a 10mm allen head bolt on the other. Just tap the original snail off of your stock axle, then tap the axle into the new V-Mar snail. We even supply a new low profile button head bolt for the other side.
All of our Snail Cams are designed to look cool, as well as give more adjustment to the rear wheel. When changing to a smaller sprocket the stock cams are often too small to allow you to take out all the slack in the chain. CNC machined from 6061 T6 aluminum and come black, red or gold anodized.

$39.95

-------------------------------------------------------------------------------------------------------------

standard
s3ggsnailcams.jpg
Gas Gas
s3ggsnailcams.jpg

S3 chain/snail can adjusters

Comes with two sets of adjusters. If your wheel is far forward you use the small adjusters & if your wheel is further back in the adjustment you use the large adjusters. This way you don't have a large adjuster hanging down prone to damage. Choose either a Gas Gas adjuster in red, black or gold. Or the standard adjusters for all other brands in black, blue, red or gold. $45.00

Enter supporting content here